Scooter Clutch Bell Housing 8mm Center Thread
search
  • Scooter Clutch Bell Housing 8mm Center Thread
  • Scooter Clutch Bell Housing 8mm Center Thread
  • Scooter Clutch Bell Housing 8mm Center Thread
  • Scooter Clutch Bell Housing 8mm Center Thread
  • Scooter Clutch Bell Housing 8mm Center Thread
  • Scooter Clutch Bell Housing 8mm Center Thread

Scooter Clutch Bell Housing 8mm Center Thread

$18.00

ScooterX Clutch Bell Housing with 8mm Center Threaded Hole. This bell housing is made for stand up gas scooter transmissions which have an 10mm shaft. The inner diameter is 3 1/16" (77.5mm). This part is what your centrifugal clutch shoes grab when you apply the gas. We recommend replacing this part whenever you put new clutch shoes in. This sized is commonly used on 33-43cc and some 49cc scooters made by ScooterX and others. You must measure your existing parts to be sure that it will fit.

Quantity

ScooterX Clutch Bell Housing with 8mm Center Threaded Hole

This bell housing is made for stand up gas scooter transmissions which have an 8mm shaft. The inner diameter is 3 1/16" (77.5mm). This part is what your centrifugal clutch shoes grab when you apply the gas. We recommend replacing this part whenever you put new clutch shoes in. This sized is commonly used on 33-43cc and some 49cc scooters made by ScooterX and others. You must measure your existing parts to be sure that it will fit.

Specifications:
- New Clutch Bell Housing
- Inside Diameter: 3 1/16" (77.5mm)
- Center hole: 8mm
- Replace this part when you replace your clutch shoes

Fits many 33 - 49cc Chinese gas scooters, mini choppers, go karts, pocket bikes and more made by:
- ScooterX
- eScooter
- Pep Boys
- Schwinn
- Ezip
- X-treme
- Roketa
- Boreem
- Evo

Will fit many more scooters than listed above. Just check the photos above. If it looks the same and the measurements match your existing, it will fit!

4300

Data sheet

Part Type
Clutching
Category
Drift Trikes
Gas Skateboard
Go Kart
Scooter
Comments (0)
No customer reviews for the moment.